Builders' Forum Archives |
Fillets at stem and stern
Posted by Dave on Jul 17, 2007
I have the hull stitched on a CH17. At the stem and stern where the bottom and side panels meet at close to 180 degrees how much of a fillet is used at the intersection of the panels?
Do you rely on filling the exterior of the joint with the fillet material and the fiberglass tape to finish the joint?
Thanks
Replies:
- Re: Fillets at stem and s by George K on Jul 17, 2007
-
Re: Fillets at stem and s by Dave on Jul 17, 2007
- Re: Fillets at stem and s by Laszlo on Jul 17, 2007
-
Re: Fillets at stem and s by Kurt Maurer on Jul 17, 2007
- Re: Fillets at stem and s by Chris J. on Jul 17, 2007
- fillets- rule of thumb by Charlie Jones on Jul 18, 2007
- Re: fillets- rule of thum by Laszlo on Jul 18, 2007
- of course. by Charlie Jones on Jul 18, 2007
- Why Tape?? by Kurt Maurer on Jul 18, 2007
- of course. by Charlie Jones on Jul 18, 2007
- Re: fillets- rule of thum by Laszlo on Jul 18, 2007
- 155 lbs? That's it, Kurt. by Robert N Pruden on Jul 18, 2007
- Hey, Dave 'N' Rob by Kurt Maurer on Jul 19, 2007
- Re: Hey, Dave 'N' Rob by Robert N Pruden on Jul 19, 2007
- Hey, Dave 'N' Rob by Kurt Maurer on Jul 19, 2007
-
Re: Fillets at stem and s by Dave on Jul 17, 2007