millcreek 16

Just cut out the sheer panels on this boat. However I messed up on one of the scarfs in that the carf was sanded too thin amd broke away leaving a small deppression on the panel. What is the easiest/best method of filling the depression so I wont see the repair on the finished painted hull?


2 replies:

« Previous Post       List of Posts       Next Post »

RE: millcreek 16

Could you get some thickened epoxy in there? It will fill the void and tie it all together. If anything is above the surface when it cures, use a scraper instead of sanding... or at least minimize sanding. Seeing as how you will be painting, it will be invisible when it's all done.


« Previous Post     List of Posts     Next Post »

Please login or register to post a reply.


Follow us on Instagram: @clcboats & @clcteardrop