Builders' Forum Archives |
Re: Bending tricks?
Posted by RayA on Aug 18, 2004
We just installed two decks last weekend (Ch 17 & Ch 17LT) and, based on advice from many previous forum discussions, we put two coats of epoxy before installation. We let the first coat cure for about 8 hours, then put a second coat on. I noticed no difference in bending difficulty compared to when I did the dry run. It didn't seem either easier or harder.
In any case, get some epoxy on before installation (if it's not too late)!
In Response to: Re: Bending tricks? by Mark Camp on Aug 18, 2004
Replies:
No Replies.