Builders' Forum Archives |
Re: weave showing
Posted by Doug Judd on Apr 22, 2004
I had one panel with "pits" after pre-varnish sanding, so I did a thin, leveling epoxy coat with a squeegee. Another quick sanding with 220 grit, and everything is fine. From 4 to 6 feet back from the boat even with only one coat of varnish, flaws are virtually undetectable. And I'm not letting anyone closer than that.
In Response to: Re: weave showing by Steve Miller on Apr 22, 2004
Replies:
- Re: weave showing by Laszlo on Apr 22, 2004
-
Revealing Post by Kurt Maurer on Apr 22, 2004
- Re: Revealing Post by Laszlo on Apr 22, 2004
- Re: Revealing Post by Mark Camp on Apr 23, 2004
- Re: Revealing Post by Laszlo on Apr 22, 2004
- .000002" by LeeG on Apr 22, 2004
-
Re: weave showing by Chip Veres on Apr 22, 2004
- Re: weave showing by Mark Camp on Apr 23, 2004
- Re: weave showing by Laszlo on Apr 23, 2004
- Re: weave showing by Mark Camp on Apr 23, 2004
-
Revealing Post by Kurt Maurer on Apr 22, 2004