Builders' Forum Archives |
rounding over for glassin
Posted by Mischa on May 6, 2004
I�m preparing to glass the bottom of the hull and I have a few questions about the steps leading up to this:
1. Should I fill in the small v shaped void between the panels on the outside of the craft that is formed by the edges of the ply wood? Or is this unnecessary since I�m going to be rounding over the chines? 2. What�s the best tool to use for rounding over the chines on a hard chined boat: hand sanding, a random orbital sander, a spook shave?
Replies:
- Re: rounding over for gla by LeeG on May 6, 2004
-
Re: rounding over for gla by Mischa on May 6, 2004
- Re: rounding over for gla by Dave Houser on May 6, 2004
-
Re: rounding over for gla by Mischa on May 6, 2004
- Re: rounding over for gla by Chris on May 6, 2004
- The Chris Technique by Kurt Maurer on May 6, 2004
- Re: rounding over for gla by Don on May 7, 2004