Builders' Forum |
|
↓ Scroll to Last Comment ↓ | Forum Guidelines | Builders' Forum | RSS |
Building a Petrel. The instructions say to use bias cut glass around the cockpit coaming. The kit includes 4" tape but it is not bias cut. Do you just take a yard or so of the fabric off the roll and cut it with a razor in to strips at a diagonal to the weave or is there a better way. Is there enough glass to do this without running short at the end.
Suggestions appreciated.
2 replies:
RE: RE Bias cut fiberglass.
» Submitted by dexter12010 - Tue, 1/26/10 » 4:58 PM
my petrel is almost done i used the glass i cut off the the edge of the deck after underside was glassed and came out good