Scarf joints on the Skerry hull panels?

A question for the Skerry builders out there.

After meticulously laying out the hull panels against the sting line, I noticed that there was a small gap at the scarf joint on the #3 panel. The top of the joint butted nicely but the seam split away to about a 1/8 of an inch. I triple checked all the measurements to ensure the panels were symmetrical. The epoxy joint appears strong enough. (based on my total lack of experience) My question is should I fill the gap with epoxy now or just continue with the assembly and fillet the space latter during the glue process? Thanks Patrick

No replies have been added to this post.

« Previous Post     List of Posts     Next Post »

Please login or register to post a reply.


Follow us on Instagram: @clcboats & @clcteardrop