ShopCam

Supplies

Builders' Forum
↓ Scroll to Last Comment ↓	Forum Guidelines \| Builders' Forum \| RSS

How much space is needed to build a passagemaker?

Submitted by Stumpoak - Thu, 10/1/09 » 11:17 AM

I would like to build a passagemaker dingy and I am curious as to how much space I will need to work without too many inconveniences? Can someone who has built one advise me? Would a 10x20 foot space be sufficient?

Thanks

2 replies:

« Previous Post List of Posts Next Post »

RE: How much space is needed to build a passagemaker?

» Submitted by jimcav - Thu, 10/1/09 » 12:07 PM

The open floor space in my workshop is about 10x16, and I had enough room to build mine. It can get a bit tight trying to bend down near the table saw or work bench, but if you're careful, that's enough space.

Check out the Passagemaker forum. There is a lot of excellent construction information that goes beyond the manual and comes from actual experiences of other PMD builders.

http://www.pmdbuilders.net/viewforum.php?f=2

Jim

RE: How much space is needed to build a passagemaker?

» Submitted by Stumpoak - Fri, 10/9/09 » 5:41 PM

Thanks for your info about the passagemaker forum and info.

Paul