Are the end caps added after the fiberglass is put on the hull or before? I note the end caps are larger than the place on bow and stern where they are applied. Do you trim them before affixing them or after? Bill
» Submitted by John, CLC - Tue, 7/28/09 » 10:48 AM
Ideally those "caps" go on before you do the fiberglass sheathing. It's intended that you do a good deal of shaping on those caps---very sharp at the waterline, gently rounded up at deck level.
RE: End Caps for Pax 20
» Submitted by John, CLC - Tue, 7/28/09 » 10:48 AM
Ideally those "caps" go on before you do the fiberglass sheathing. It's intended that you do a good deal of shaping on those caps---very sharp at the waterline, gently rounded up at deck level.