Builders' Forum |
|
| ↓ Scroll to Last Comment ↓ | Forum Guidelines | Builders' Forum |  RSS
|
seperating the wooden parts from a kit
The Peeler is shipped in 4x8 panels with the tabs attached to each precut part. How much wood is holding the part? How are they seperated? I've wondered, do you use a saw or can they be just snapped out of the sheet??? Thanks, Ken.
2 replies:
RE: seperating the wooden parts from a kit
Rec'd the building manual for the Peeler. There is alot of information packed into one book.
RE: seperating the wooden parts from a kit
» Submitted by Autonomous - Sun, 12/2/12 » 1:25 PM
At the very least I'd score the tabs with a chisel or knife to eliminate the risk of splintering if you snap the parts out. beyond that use whatever works.