Builders' Forum |
|
↓ Scroll to Last Comment ↓ | Forum Guidelines | Builders' Forum | RSS |
I'm building a Shearwater 16 and would like to mill some strips in addition to those included in the kit. Does anyone know what the correct radius of the cove and bead bit should be? My guess is a 3/16" radius but I'm not sure.
Thanks for any advise you can give me.
2 replies:
RE: cove and bead router bit
Stacked Flute and Bead Router Bits
http://www.mlcswoodworking.com/orderstatus/html/smarthtml/pages/bt_flute.html
RE: cove and bead router bit
» Submitted by Dogan - Wed, 12/7/11 » 2:46 PM
The standard bead and cove set for strip building is 1/4" radius.
http://www.leevalley.com/US/wood/page.aspx?cat=1,46168,46174&p=30155