Quest. for Charlie Jones

Posted by Brad Shook on May 11, 2007

Hi Charlie,

I am going to take the plunge and put Bristol finish on a Merganser this weekend.

I intend to roll it (with urethane compatible roller covers) and tip off with a foam brush.

Is this going to be ok and can you give me a few pointer?

I will be doing the tech page "practical application" where you put 3 coats on with no sanding and then let cure and sand with 220 (dry?) before a final coat.

I printed off the tech pages so I have the correct "information" so to speak. Will pouring and mixing 8 oz.'s at a time be enough to do an 18ft x 22" Merganser sides and deck?

Thanks Charlie, Brad



Follow us on Instagram: @clcboats & @clcteardrop