Re: sigh- If you are glas

Posted by Mac on Mar 20, 2005


What I did on this most recent deck was to make a quick pass with 80 grit, then with the grain with cabinet scrapers prior to 2 oz glass. This was to ensure removal of any swirls which I noticed showed up through thin glass under certain light on my last boat. (I know I'm being anal, but I figure after practicing on a few boats, I'll go for a coffee table).

I also have way too much time on my hands during these Canadian winters.

Send me masts - I'll load test em' fer ya! The main reason I sand a bit is to ensure that the glass doesn't snag while smoothing it out

In Response to: sigh- If you are glassing by Charlie Jones on Mar 20, 2005



Order thru September 30th for a
FREE Supplies Kit Worth $80!

Follow us on Instagram: @clcboats & @clcteardrop