Re: Tracing out the Deck.

Posted by Myron on Jun 28, 2004

I did my most recent one by laying the plywood on the ground and putting the boat up side down on the wood. Then I rocked the boat to one side (estimate of curvature) and outlined the deck. Rocked the other way for the other side. After I had both deck pieces laid out on one plywood sheet (to make sure they fit) I cut a little larger than I needed. It worked fine.

In Response to: Re: Tracing out the Deck. by Dick R on Jun 28, 2004

Replies:

  • Myron... by Kurt Maurer on Jun 28, 2004


 



Follow us on Instagram: @clcboats & @clcteardrop