Builders' Forum |
|
↓ Scroll to Last Comment ↓ | Forum Guidelines | Builders' Forum | RSS |
Countersinking brass rub strips
Are these:
hard enough to use on these:
?
2 replies:
RE: Countersinking brass rub strips
Thanks la,
Picked up my set on your recommendation yesterday,
Laszlo
RE: Countersinking brass rub strips
» Submitted by lafisher - Fri, 11/6/09 » 10:45 PM
Laszlo;
I have used router bits made of the same material to chuck into a drill press and machine solid blocks of brass to make a handplane. Granted the milling passes were very shallow, but the router bit was no worse for wear when I was done. So, the answer would be an unequivical yes for using those bits on brass.