Builders' Forum |
|
↓ Scroll to Last Comment ↓ | Forum Guidelines | Builders' Forum | ![]() |
I just tried to dry fit the daggerboard trunk and discovered it is too high. The notch does not fit u deer the center of the bulkhead and the top of the trunk assembly is higher than the top of the frame. I do t know if this is normal or if I messed up somewhere but it's apparent that assembly needs to be trimmed. I can trim the bottom of th3 assembly and/or extend the notch some. In the later case I will have to trim the top of the assembly so it lines up flush with the top of the bulkhead. Is there a recommended approach? Bruce
No replies have been added to this post.