Builders' Forum |
|
↓ Scroll to Last Comment ↓ | Forum Guidelines | Builders' Forum | RSS |
I purchased a pair of Kayak Toggles to use as handles on my Chesapeake 17. However, I am not sure which knot to use to install them. There are three holes and I imagine I should run the cord through my deck hardware and then into 2 of of the holes. Next, I pull the line to the end of the toggle and make a knot and then push the knot into the toggle... but my knot is too big. I am trying to get it to the end result like the picture on the website.
2 replies:
RE: Installing Kayak Toggles
» Submitted by twofootartist - Thu, 6/9/11 » 9:27 AM
That happened to me too. It finally dawned on me to pull one end out one side and the other out the other side, and tie a knot in each end separately. -Wes