Builders' Forum Archives |
Re: San O Help, sheer cla
Posted by James Abell on Dec 29, 2007
Ok thanks, I will dry test today.
However, the side panel's side profile at the top edge still curves upward each end (this can easily be seen from the plans), I presume I have to bend the sheer clamp wood slightly to match this then clamp, then do again until I get to the end and make sure its all flush with the side panel?
Thanks.
http://www.paddleboardingscotland.com
In Response to: Re: San O Help, sheer cla by theo on Dec 29, 2007
Replies:
- Re: San O Help, sheer cla by theo on Dec 29, 2007
- Re: San O Help, sheer cla by OOPS on Dec 30, 2007
- Re: San O Help, sheer cla by theo on Dec 30, 2007
- Re: San O Help, sheer cla by George K on Dec 30, 2007
- Re: San O Help, sheer cla by James Abell on Dec 30, 2007