Re: coaming on Mill Creek

Posted by Chris J. on Nov 11, 2007

Jim...I made my coaming from 6mm plywood. I rounded over the inside edge and then installed the rim up to the outside top edge as shown. I milled the rim from mahogany. When I clamped the rim to the coaming I allowed the coaming to be just a hair proud of the rim. Once the epoxy cured I sanded the proud edge down to the rim...this ensured a real smooth top edge.

Hope this helps.

Chris

In Response to: coaming on Mill Creek 13 by Jim Raffini on Nov 11, 2007

Replies:

• Re: coaming on Mill Creek by Jim Raffini on Nov 12, 2007
  • Re: coaming on Mill Creek by Chris J. on Nov 12, 2007
    • Re: coaming on Mill Creek by Steve Miller on Nov 13, 2007
      • Re: coaming on Mill Creek by Steve Miller on Nov 13, 2007
        • Re: coaming on Mill Creek by Jim Raffini on Nov 15, 2007
          • Re: coaming on Mill Creek by Steve Miller on Nov 24, 2007