Re: Side panel joint help

Posted by Kyle Lindstrom on Aug 25, 2007

Thanks guys for your quick help. I had always thought it was edge to edge but a couple of pictures in the manual seem to show it as an overlap joint. Nothing was mentioned in the plans about the joint so that is why the question popped up. Thanks again and I'm back to building. I will keep the group updated on my progress.

Kyle

P.S. Interesting about rounding over the edges of the joint. I thought a sharp edge would hold better for gluing.

In Response to: Re: Side panel joint help by OOPS on Aug 25, 2007

Replies: