Re: MC 13 Hull

Posted by CLC on Jun 7, 2007

I'm not sure it's possible to assemble that particular geometry in a hull without ending up with little gaps at the bow and stern. Certainly every Mill Creek I ever built had them. When you fill the interior seams with thickened epoxy, those gaps will be filled, and then vaporized when you sand the bow and stern smooth later in the process while preparing for exterior fiberglass. Press on.

In Response to: MC 13 Hull by Gafric on Jun 7, 2007

Replies:

• Re: MC 13 Hull by gober on Jun 8, 2007
  • Re: MC 13 Hull by Gafric on Jun 8, 2007