Builders' Forum Archives |
Re: CLC Simplify
Posted by Darryl on Jan 18, 2006
I'm a few steps ahead and now rounding the edges to prepare for glassing on my Shearwater 17. I rounded the corners roughly a 1/4" radius and exposed a layer of plywood down the sides and hull. On top I just slightly sanded. Looking at CLC pictures & reading the instructions it looks you may be able to do this without exposing any layers. I am probably going to paint the hull anyways but can you actually do this step without exposing the layers?
In Response to: Simplify by CLC on Jan 18, 2006
Replies:
- Re: CLC Simplify by CLC on Jan 18, 2006
-
Re: CLC Simplify by Darryl on Jan 18, 2006
- Re: CLC Simplify by Jim S on Jan 18, 2006
- Re: CLC Simplify by Chris J. on Jan 19, 2006
- Re: CLC no bevel ok? by James Eager on Jan 19, 2006
- Re: CLC no bevel ok? by CLC on Jan 19, 2006
- It's not tricky by LeeG on Jan 20, 2006
- Re: CLC no bevel ok? by James Eager on Jan 19, 2006
- Re: CLC Simplify by Chris J. on Jan 19, 2006
- Re: CLC Simplify by Jim S on Jan 18, 2006
-
Re: CLC Simplify by Michael on Aug 14, 2007
- Re: CLC Simplify by john on Aug 14, 2007
- Re: CLC Simplify by Ryan Sharrow on Aug 14, 2007
- Re: CLC Simplify by Jon T on Aug 15, 2007
- Thanks! by Michael on Aug 16, 2007
- Re: CLC Simplify by Jon T on Aug 15, 2007
- Re: CLC Simplify by Ryan Sharrow on Aug 14, 2007
- Re: CLC Simplify by john on Aug 14, 2007
-
Re: CLC Simplify by Darryl on Jan 18, 2006