Builders' Forum Archives |
Tape it up
Posted by Eric Swenson on Oct 7, 2005
First build here, getting ready to wire the craft together. Thought I would check out how the craft looks before wiring , so used masking tape and put it together. Then I had the brilliant(maybe not?) idea to leave it taped together and start drilling holes and going at it with the wire. Haven't done it yet, so I am humbly asking..is this a bad idea and what are the down sides to stitching the panels together this way?
I can take the harassment, so lay it on me...thank you. Eric
Replies:
- Re: Tape it up by jeff wong on Oct 7, 2005
-
Re: Skipping The Stitches by Mac on Oct 7, 2005
- Re: Skipping The Stitches by John Short on Oct 7, 2005
- Re: Skipping The Stitches by Tom M. on Oct 7, 2005
- Re: Skipping The Stitches by FrankP on Oct 10, 2005
- Re: Skipping The Stitches by Jim S on Oct 10, 2005
- Re: Skipping The Stitches by FrankP on Oct 10, 2005
- Re: Skipping The Stitches by Tom M. on Oct 7, 2005
- Re: Skipping The Stitches by John Short on Oct 7, 2005
-
Re: Skipping The Stitches by Mac on Oct 7, 2005
- Re: Tape it up, then Wire by Eric Swenson on Oct 7, 2005
-
Re: Tape it up, then Wire by Eric Swenson on Oct 7, 2005
- Re: Tape it up, then Wire by Steve Miller on Oct 7, 2005
- Re: Tape it up, then Wire by FrankP on Oct 10, 2005
- Re: Tape it up, then Wire by J.Schott on Oct 7, 2005
- Re: Tape it up, then Wire by Steve Miller on Oct 7, 2005
-
Re: Tape it up, then Wire by Eric Swenson on Oct 7, 2005