Builders' Forum Archives |
plywood warping
Posted by Mislav on May 3, 2005
Today was very humid here and I noticed my 6mm plywood sheet started to warp. It appears that one of the face veneers is slightly thinner. Other (4mm) panels look fine. Is there anyhing I could do about it? I cut the bulkheads out of it. My initial idea is to wait until the air gets dry and then seal it with epoxy.
Replies:
- Re: plywood warping by Scot on May 3, 2005
-
Re: plywood warping by Mislav on May 4, 2005
- Re: plywood warping by Kyle T on May 4, 2005
- Re: plywood warping by Howard on May 4, 2005
- Re: plywood warping by Karl on May 4, 2005
- Re: plywood warping by Mac on May 5, 2005
- Re: plywood warping by Mike D on May 5, 2005
- Re: plywood warping by Mislav on May 5, 2005
- Re: plywood warping by Karl on May 4, 2005
- Re: plywood warping by Howard on May 4, 2005
- Re: plywood warping by Kyle T on May 4, 2005
-
Re: plywood warping by Mislav on May 4, 2005
- It breaths! by Mislav on May 5, 2005
- Re: It breaths! by Karl on May 5, 2005