Builders' Forum Archives |
Re: sealing rigging screw
Posted by LeeG on Apr 21, 2005
One of the things I noticed about some clc kayaks and the first few I made is that an occasional rigging screw strayed to the edge of the sheer clamp or through it. Beside the problem that presents for hands or gear it opened up sealed wood and allowed damp sheer clamps to stain the exterior of the hull. And if you didn't drill the holes for the screws with a tapered bit (Fullers bit?) then it was very easy to strip the soft cypress against the hard/epoxied ply deck when the screw was sent in lubed with silicone sealant.
In Response to: Re: sealing rigging screw by Peter on Apr 21, 2005
Replies:
- Re: sealing rigging screw by Howard on Apr 21, 2005
-
Re: sealing rigging screw by Chris Taylor on Apr 22, 2005
- Re: sealing rigging screw by LeeG on Apr 22, 2005
- Re: sealing rigging screw by Steve on Apr 22, 2005
- Re: sealing rigging screw by LeeG on Apr 22, 2005
-
Re: sealing rigging screw by Chris Taylor on Apr 22, 2005