Re: coaming profile Quest

Posted by Doug Rhude on Nov 2, 2004

I've taken the "EARS" off of the combing on both my boats(17LT & Pax 20),...Amazing what an inch or two can do for entry/exit! Just leave the outer diameter as is & make the combing width the same all the way around... Be sure and keep an eye on thickness of bottom rings as you round off the inside edge!...Caution!... river paddler...I don't roll...just stand up!(or swim!)...Doug Rhude

In Response to: Re: coaming profile Quest by Mac on Nov 2, 2004

Replies:

No Replies.