Builders' Forum Archives |
Re: Varnish Application
Posted by Steve Miller on Aug 27, 2004
Ignore the label. I bet they tell you sand between coats with 220 too.
If you have not varnished before then you will probably have better results with a roller.
If in doubt then do a test. Put some on with a roller and tip. How does it look? I suggest the 4" white foam round end rollers from Home Depot. Add a couple of ounces of Penetrol to the varnish too. Should be fine.
Remember it you don't like it then just sand it off and start over.
In Response to: Varnish Application by Rob on Aug 27, 2004
Replies:
No Replies.