Builders' Forum Archives |
Removing tape remnants
Posted by Homer on Aug 18, 2004
Fellow builders, After applying epoxy coats to my hull, while building, I used some 3" wide plastic tape on the surface to cover any drips from some other work. When I was done, I attempted to remove the tape, but found it left quite a bit of adhesive and tiny tape flecks on the hull. I assume these will easily sand off, however, I am wondering if there is another simple application to wipe on that would get the crud off, but not affect the epoxy on the hull.
Thanks
Replies:
- Re: Removing tape remnant by TomS on Aug 18, 2004
- Re: Removing tape remnant by Laszlo on Aug 18, 2004
- Re: Removing tape remnant by RonC on Aug 19, 2004