Builders' Forum Archives |
System 3 over MAS?
Posted by Baldwon on May 4, 2004
My specific question was not addressed on the forum as far as I can see. My question is if MAS is 8 - 72hours in the cure process on the 1st layer hull glassing, what specifically could go wrong if I layered System 3 over that?
In Response to: MAS then Systm 3 to fill? by Baldown on May 4, 2004
Replies:
- Re: System 3 over MAS? by Rick on May 4, 2004
- Re: System 3 over MAS? by Terry Mcadams on May 4, 2004
-
Re: System 3 over MAS? by Mark Camp on May 4, 2004
- Re: System 3 over MAS? by Steve Miller on May 4, 2004
- Re: System 3 over MAS? by Mark Camp on May 5, 2004
- directions?! by LeeG on May 5, 2004
- Re: System 3 over MAS? by Mark Camp on May 5, 2004
- Re: System 3 over MAS? by Steve Miller on May 4, 2004
-
Re: System 3 over MAS? by Mark Camp on May 4, 2004