Builders' Forum |
|
↓ Scroll to Last Comment ↓ | Forum Guidelines | Builders' Forum | RSS |
OK to drill through plywood bulkheads?
I'm building a Dory (still!!) and had an idea about drilling 3/4" holes through the upper portion of the plywood bulkheads, a couple inches down from the rail. The idea is to tie fenders through these holes. Does anyone know if this would compromise any structural integrity?
thanks
lima
1 reply:
RE: OK to drill through plywood bulkheads?
» Submitted by George K - Sat, 6/8/13 » 9:02 PM
Shouldn't be a problem at all.
George K