seperating the wooden parts from a kit

The Peeler is shipped in 4x8 panels with the tabs attached to each precut part. How much wood is holding the part? How are they seperated? I've wondered, do you use a saw or can they be just snapped out of the sheet???  Thanks, Ken.


3 replies:

« Previous Post       List of Posts       Next Post »

RE: seperating the wooden parts from a kit

At the very least I'd score the tabs with a chisel or knife to eliminate the risk of splintering if you snap the parts out. beyond that use whatever works.

RE: seperating the wooden parts from a kit

Rec'd the building manual for the Peeler. There is alot of information packed into one book.

« Previous Post     List of Posts     Next Post »


Please login or register to post a reply.