Re: One San O clamp done.

Posted by George K on Feb 4, 2008


Not a problem but I'd match the two sides and plane/sand off the same amount on both. You'll have to use your own judgement as to beveling the inside corners, but 2-3mm isn't too big a deal. Beveling the edge lightens the boat a bit and isn't going to weaken the structure. I built two San 0 14's and beveled the heck out of the sheer clamps! They're still both holding together.


In Response to: One San O clamp done.... by James Abell on Jan 31, 2008


No Replies.


Special Financing with Blispay

 CLC's Fall Kit Sale