Builders' Forum Archives |
Re: Filleting joints....
Posted by Joe M on Dec 16, 2007
All good advice. And I see there are so many ways to go about things.
I will incorporate a little of everyones experience into my build.
I will weld the joints inbetween wire, pull the wire, tape off and fillet to a minimum and save soaking the end grain for when the outside hull glass is being wet out.
Thanks again everyone.
In Response to: Re: Filleting joints.... by Darryl on Dec 15, 2007
Replies:
- Re: Filleting joints.... by LeeG on Dec 16, 2007