Re: MC 16.5 end pour

Posted by Doug Arndt on Oct 3, 2007

My only experience is the two MC 16.5's my brother and I are building, and we used the micro-balloons. There is a good amount of epoxy in thoses ends, so my guess is this would be the most productive weight saving spot. I've not read of any strength issues. Trust others with experience will add some comments. The manual does suggest this an an option, so I'd expect if that were an issue it would have been mentioned or not suggested.

In Response to: Re: MC 16.5 end pour by Mark on Oct 1, 2007

Replies:

No Replies.