Re: Installing deck proce

Posted by George K on Oct 1, 2007

Kyle,

First you want to roll unthickened epoxy on the underside of the decks to seal them. Before it cures install the decks, aft first. A few nails down each side at a time is best. The link is to the shop tips on how to get a good joint between fore and aft decks.

George K

In Response to: Installing deck process? by Kyle Lindstrom on Oct 1, 2007

Replies:

• Re: Installing deck proce by Kyle Lindstrom on Oct 1, 2007
  • Re: Installing deck proce by Kyle Lindstrom on Oct 2, 2007
    • Re: Installing deck proce by Jim E on Oct 3, 2007
  • Re: Installing deck proce by Woodie on Oct 3, 2007
    • Re: Installing deck proce by Doug Arndt on Oct 3, 2007
      • Re: Installing deck proce by George K on Oct 3, 2007
        • Re: Installing deck proce by Jim E on Oct 3, 2007
          • Re: Installing deck proce by Kyle Lindstrom on Oct 5, 2007