Re: MC13 Bulkhead

Posted by CLC on Jul 19, 2007

1.5 inches! Something is awry. Are you building from plans? It's been a year since we built one in the shop, but the bulkheads were good fits in the Mill Creek 13 kit. I just compared the kit bulkheads to the MC13 in our showroom and they were right on.

If you had the bottom turned around 180 degrees, you might be off by about 3/4" on each side, but not 1.5 inches on each side.

Send me an email at [email protected] with a photo and I'll take a look to see what's going on.

In Response to: MC13 Bulkhead fit issue by mlamoreau on Jul 19, 2007

Replies:

No Replies.