Re: Bulkhead Fit

Posted by Richard K on Jan 18, 2007

Willy - just a thought, the panels move relative to each other when they go from flat to spread, so if you wired the bottom two panels to the two side panels before spreading the beam you may have introduced some stresses to the hull that are pulling it out of shape. But hey, as long as the sheers are level and the shape is fair, then what does it really matter if you move the bulkeads a bit?

In Response to: Bulkhead Fit by Willy on Jan 15, 2007


No Replies.


Special Financing with Blispay

 CLC's Fall Kit Sale