Posted by -Karl on Dec 7, 2006

and take a deep breath. The concave surfaces and sharp angles are a lot harder to work around than the outside of the hull. My cockpit didn't come out the greatest either, so once I finished it, I painted the inside. Good enough for me! The outside of the hull went a lot better, just take some time to smooth out the glass and make sure it lays out correctly. It drapes pretty well and will conform even better once it is wet. The only place I had any issue was the very plumb stern, and all that requird was a little trimming to get it right.

In Response to: glass probs by Tom S on Dec 7, 2006


No Replies.


Special Financing with Blispay

 CLC's Fall Kit Sale