Re: Bending the deck

Posted by Mic on Jul 6, 2006

Hi

Not sure if you are building from a kit or from plans . . however when I buid my kayak I had the same problem with the deck. The problem in my case was that I had bought a crappy quality of ply. The three sheets of wood in the board were NOT equally thick, the middlesheet were alot thicker. We were three people who tried to press it down . . but no luck. Went away 'n bought ply that had all three sheet equally thick anf those boards almost folded themselves around the kayak :-)


My page

In Response to: Bending the deck by Bill Lapcevic on Jul 6, 2006

Replies: