Re: bulkhead position & d

Posted by Jamie on Jun 15, 2006

The bulkhead is about 1 1/2 inches aft, but this means that the top edge of the bulkhead is about 3/8 inch lower than the top of the sheer clamp. I am afraid that the deck will not have support during bending and will flatten out, and that I will have to go back and fill the gap between the deck and bukhead with a big old dollop of schmutz.

In Response to: Re: bulkhead position & d by Brad Shook on Jun 15, 2006



Special Financing with Blispay

 CLC's Fall Kit Sale