Re: Hatch curve

Posted by Ed, NY on Mar 31, 2006

I guess I'm a bit slow to respond but I had a twist and spring back problem with a double layer hatch. I followed someones post on this site. A few days after the initial gluing, I used a heat lamp to warm the whole thing up and then reclamped it with a few shims in what seemed the right places. It held when cool. Not perfectly but good enough to keep a seal. 6 of those twist tab thingies CLC sends help make sure it is down tight.ht4k

In Response to: Re: Hatch curve by M Davis on Mar 29, 2006

Replies: