Bulkheads

Posted by Tim on Feb 24, 2006

Ok, my wonder of the day. WR18 build, going good. Thanks for the help along the way this far.

I am at a point of fitting in the bulkheads. I have them roughly layed out per the specs. When I go to install them there is no way that they eant to fit in the location with out some trimming of material. The the forward and aft seem ok. But the center two will require some trimming, in my opinion.

Sould I just go ahead on and trim to fit? I know that they need to fit snug and basically "form the hull" profile. But without the trimming, it ain't happening. I am looking at 2"-4" out of placement at this point. which greatly affects the cockpit area.

Thanks again for the help.

Replies:

• Re: Bulkheads by CLC on Feb 24, 2006
  • Re: Bulkheads by tim on Mar 3, 2006