Re: fillets

Posted by paul on Oct 10, 2005

Yes Jim, you're right on the target. That is the technique. But this means that the fibergalss tape will not get bonded to a continuous "green" fillet, only the short infill fillet sections where you've removed the wires.

I assume, since its been done, that this creates a sufficient bond. But its then confusing when other builders reference the importance of getting the tape to bond to green fillets.

I guess the rest of my inquiry was toward the standard approach of leaving the wires in place. The instruction manual indicates using a 2" radius scarper to tool the fillet. This tool, in my experience, ran into the wires.

Any one else have similar experience ?

In Response to: Re: egads by Jim S on Oct 10, 2005

Replies:

• Re: fillets by Laszlo on Oct 10, 2005
  • Re: fillets by Mislav on Oct 11, 2005
    • Re: fillets by Mark Camp on Oct 11, 2005
• Re: fillets by LeeG on Oct 10, 2005
  • Re: fillets by Mac on Oct 11, 2005
    • Re: fillets by clark tuttle on Oct 11, 2005