Builders' Forum Archives |
Re: Tape it up, then Wire
Posted by Eric Swenson on Oct 7, 2005
Guys, my fault. My idea was to use the tape to hold the panels in position temporarily , then drill hiles for the wire. I would NOT skipp the use of wire ties. The panels would be held in position ready to wire rather than hanging over the side of the table as twisting progressed, that's all.
In Response to: Tape it up by Eric Swenson on Oct 7, 2005
Replies:
- Re: Tape it up, then Wire by Eric Swenson on Oct 7, 2005
-
Re: Tape it up, then Wire by Steve Miller on Oct 7, 2005
- Re: Tape it up, then Wire by FrankP on Oct 10, 2005
- Re: Tape it up, then Wire by J.Schott on Oct 7, 2005
-
Re: Tape it up, then Wire by Steve Miller on Oct 7, 2005