So Joe I gotta question

Posted by Gober on Jun 22, 2005

I too was doing some veneer work last night. I was onlaying a 32 inch long Lone Star flag behind my cockpit. It went down great, smooth lines and all. I was using Walnut, Cherry and birch veneers. Some of my veneer has humps, meaning it does not want to lay flat. The pieces I used last night were almost totally flat so I didnt have a problem, but is there any tricks to get the humps out of the other veneer I have? Also I used contact cement to bond my veneer what did you use?

In Response to: Re: Filling the bucket by Mac on Jun 22, 2005

Replies:

No Replies.