Builders' Forum Archives |
hope this is a sloution
Posted by ray on Apr 9, 2005
I have pinned the battons to a flat surface (workbench). On top of these battons I have laid the hatch covers (flush I hope). Rather than use clamps, I have used scrap strips, placed over ply and screwed these into the workbench. These strips seem to have done a good job in bending the hatch cover to the contours of the battons (no warping).
Epoxy is curing now. I shall let you know tomorrow whether this works.
all the best
ray
In Response to: Re: warped hatch by Ken Leffert on Apr 7, 2005
Replies:
- Re: hope this is a slouti by Ken Leffert on Apr 9, 2005
-
Re: hope this is a slouti by LeeG on Apr 10, 2005
- Re: hope this is a slouti by Ken Leffert on Apr 10, 2005
- Re: hope this is a slouti by LeeG on Apr 10, 2005
- Re: hope this is a slouti by Ken Leffert on Apr 10, 2005
-
Re: hope this is a slouti by ray on Apr 10, 2005
- Re: hope this is a slouti by LeeG on Apr 10, 2005
- Re: hoep hihs a is slouti by CLC on Apr 10, 2005
- Re: hoep hihs a is slouti by ray on Apr 11, 2005
-
Re: hope this is a slouti by LeeG on Apr 10, 2005