Builders' Forum Archives |
warped hatch
Posted by ray on Apr 7, 2005
The final bit of woodwork before painting - yipee!
This eve I tried to bend the hatches as per the manual instructions. I had a dry run first - using battons on the underside of the hatch. These battons have been cut to the same radii as the front deck. I have clamped these to the underside of the hatch.
Problem - as i look at the hatch from front to back, I see that it is twisted. I need to find a solution before epoxying - any ideas?
Replies:
- Re: warped hatch by George K on Apr 7, 2005
-
Re: warped hatch by ray on Apr 8, 2005
- Re: warped hatch by Mac on Apr 8, 2005
- Warped humor? by Karl on Apr 8, 2005
- Re: Warped humor? by Mac on Apr 8, 2005
- Warped humor? by Karl on Apr 8, 2005
- Re: warped hatch by LeeG on Apr 8, 2005
- Re: warped hatch by Mac on Apr 8, 2005
-
Re: warped hatch by ray on Apr 8, 2005
- Re: warped hatch by Ken Leffert on Apr 7, 2005
-
hope this is a sloution by ray on Apr 9, 2005
- Re: hope this is a slouti by Ken Leffert on Apr 9, 2005
- Re: hope this is a slouti by LeeG on Apr 10, 2005
- Re: hope this is a slouti by Ken Leffert on Apr 10, 2005
- Re: hope this is a slouti by LeeG on Apr 10, 2005
- Re: hope this is a slouti by Ken Leffert on Apr 10, 2005
- Re: hope this is a slouti by ray on Apr 10, 2005
- Re: hope this is a slouti by LeeG on Apr 10, 2005
- Re: hoep hihs a is slouti by CLC on Apr 10, 2005
- Re: hoep hihs a is slouti by ray on Apr 11, 2005
- Re: hope this is a slouti by LeeG on Apr 10, 2005
- Re: hope this is a slouti by Ken Leffert on Apr 9, 2005
-
hope this is a sloution by ray on Apr 9, 2005