it's a common question

Posted by LeeG on Mar 27, 2005

Which one would ask after looking at the drawing at the bottom of this page as it would imply that the radius is constant with a straight line from deck beam to bow. There's a certain amount of three dimensional warping the big sheet of ply goes through that is a consequence of the sheer and deck beam curve. Also the direction of the grain can make the curve vary a tiny bit.

http://www.clcboats.com/cambereddecks.php/cart_id=6c64e26aad10753aefbff32ef1237f5a/

In Response to: Re: fore bulkhead too low by Rob, Australia on Mar 27, 2005

Replies:

• Re:bulkhead too low by Rob, Australia on Apr 5, 2005