Builders' Forum Archives |
Re: fore bulkhead too low
Posted by CLC on Mar 27, 2005
>>>>>>>>>After carefully tracing the fore bulkhead profile for the Ch16.,I found it was too small. This was picked up by running a string line from the deck beam to the bow and measuring the distance from the string to the top of the 'wrong' bulkhead.
:>>>>>>>>>>>>>>>>>>
The deck is not a section of a cone or a cylinder between deckbeam and the tip of the deck; unlike the string, it curves down to the bulkhead and then sweeps up to the bow. Lay a straightedge on the plans between the tip of the bow and top of the deck at the cockpit; you'll see the curve.
In Response to: Re: fore bulkhead too low by Rob on Mar 27, 2005
Replies:
No Replies.