Re: Foam in flotation tan

Posted by Mac on Jan 27, 2005

I have no idea of how to calculate the horsepower or whatever that is generated by expanding foam, but I blew out a 1/2" plasterboard wall where the studs were only about 8" apart. I did not leave large enough escape holes. It was awsome to hear and to watch. It was a full day to clean up and rebuild - and that was just gyprock, not a boat. If I recall, this stuff also generates a ton of heat (like epoxy licking off). I've never considered using it again.

In Response to: Re: Foam in flotation tan by terry on Jan 27, 2005

Replies:

• Re: Foam in flotation tan by terry on Jan 27, 2005